Is there a way to fix this? FYI, I've been keeping the light off to avoid something bad (fire) happening. Lastly, I've also noticed a buzzing sound when the light is on. The dimmer switch that I bought is a Lutron C-L Dimmer. So my question is, is there a way to wire the dimmer switch to have it solely operate the light and have the fan be controlled by the pull cord with the dimmer switch that I have already purchased? Do I need to buy a different type of dimmer switch? Or should I scrap the idea of having ambiance in my living room from my ceiling and invest in some lamps?! If the switch is two-way you will use all three terminals. To replace a single one-way light switch, only use the terminals marked Com and L1. Most dimmer-switches will be two-way (have 3 terminals). When I capped one or the other black wires from the wall, the dimmer still controlled the fan motor, or the whole fixture did not work, if I am remembering correctly. If you have a metal face-plate on the switch, install a PVC guard between the wall and face-plate. When I had red to red connected, with the 2 black wires from the wall connected to the black wire on the dimmer, the dimmer switch controlled the fan motor and the light did not even turn on. Is the "push wire" hole on the original switch just a constant source of power and is not operated by the switch? This combination controls the light appropriately, however the fan is not working at all.įrom this combination, I have deduced that the red wire controls the fan. And I have capped the red wire from the wall. And the 2 black wires from my wall are connected to the black and red wires on the dimmer switch box. I have left the red/white striped wire capped, as instructed. On the dimmer switch that I bought, there is a ground wire, a red wire, a black wire (and a red/white striped wire, which the instructions said to cap as it could be used for 3 way switch, which I don't think I need for this job.) On the switch, the black wires were attached to 2 brass screws, the ground wire attached to a blackish-green colored screw, and the red wire was inserted into a small whole in the back of the switch labeled a "push wire". In the switch box there were 2 black wires, 1 red wire, and the ground wire. This is what I continue to achieve after I have installed the dimmer switch for the light. Correct me if I've been told wrong!īefore I attempted to install the dimmer, there was one switch on the wall that controlled the light and the fan was operated by the pull cord attached to the fixture. I have read that installing a dimmer for the fan is dangerous, however I have been told that having the dimmer only control the light, not the fan and the light, is okay. I am attempting to install a dimmer switch to solely operate the light on my ceiling fan light fixture.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |